Utility Locate At Mall - Altoona, PA

A General Contractor called Ground Penetrating Radar Systems to locate anything subsurface before saw cutting in an Altoona mall. The General Contractor was hired to saw cut an area in the mall and run a conduit through the area. To complete this task, there needed to be a 100 foot trench cut at approximately 2 feet deep. They hired Ground Penetrating Radar Systems, who specializes in locating anything subsurface. Sam Hart was the technician hired to complete this task. He was able to scan the concrete to verify anything running through or directly beneath the concrete. Sam Hart mapped out any potential conflicts, which he communicated with the General Contractor before they began their saw cutting.

If you need any assistance before trenching, you can reach Sam Hart at 717-798-5721 or sam.hart@gprsinc.com. It is always better to be certain of where everything is before saw cutting, core drilling, or excavating, than to go into the job blindly and risk the safety of others. This particular project was in York, but Sam covers the entire mid-state area. He often works in Altoona, Williamsport, Hershey and Lancaster.